Detailed explanation of suspended laying steps for

Laminate floor is also called impregnated paper laminated wood floor, which is composed of wear-resistant layer, decorative layer, substrate layer and balance layer. The installation of laminate floor generally adopts suspension paving method, which is relatively simple and fast. Although the installation is generally the responsibility of the manufacturer, if the owner understands its installation method, it will be of great benefit to the supervision and acceptance of floor installation

Step 1: treat the ground base

before paving the laminate floor, it is necessary to ensure that the ground is flat and dry. The flatness of the ground needs to meet the standard, and the ground of the blank room is generally leveled with cement. Attention should also be paid to the moisture content of the ground. If the moisture content is too high, moisture-proof treatment needs to be done

step 2: lay the floor mat

the function of the floor mat is moisture-proof and mute. Before laying the laminate floor, it is necessary to pad a layer of floor mats on the ground. Generally, the cushion shall be paved on the whole paved ground in a flat and non overlapping manner, and the joints shall be firmly bonded with adhesive tape. How to save money in decoration? Home decoration network, free design budget quotation. Damp proof film shall be laid under the floor mat in wet ground and geothermal environment. The width joint shall be overlapped by more than 200mm and bonded tightly with adhesive tape. The wall corner shall be turned up to the same height as the skirting line

step 3: install laminate floor

now the edge of laminate floor is generally a latch structure with mortise and tenon. When installing such a structure, it is good to ensure that the two kinds of splicing are close, without using floor glue to connect the floor

step 4: install the skirting line

it is necessary to reserve the position of the skirting line between the floor and the wall, which is usually clamped in the middle with small wooden blocks. After installing the floor, you can remove the small wooden blocks and install the skirting line. Generally, the skirting line is stuck into the reserved seam, and then nailed with special nails

邯郸男科医院

广州男科医院

合肥不孕不育医院

南通男科医院